KRTR-PRO-S1 Installation Instructions
Installation instructions for the Kryptonite Stage 1 Tie Rods (KRTR-PRO-S1). Used with: Kryptonite Stage 1 Tie Rods for 2022-2026 Polaris Pro R / Turbo R / Pro S, Kryptonite Stage 1.5 Tie Rods for 2022-2026 Polaris Pro R / Turbo R / Pro S.
Quick reference
- Part numbers: KRTR-PRO-S1
- Inner joint to steering rack: 100 ft-lbs
- Outer knuckle nut: 52 ft-lbs +90°
- Wheels: 148 ft-lbs
- Toe (vehicle on the ground, steering straight ahead): 1/8”
- Jam nuts (after setting toe): 89 ft-lbs
Text version of these instructions
Removal
- Park the vehicle on a clean, level surface. Raise the front of the vehicle and remove both front wheels/tires. Support the vehicle securely with jack stands and chock the rear tires.
- Using an 21mm socket, remove the nut from the outer tie rod end. Separate the tie rod end from the steering knuckle.
- Remove the dust boot clamps from the steering rack and slide the boot back to expose the inner tie rod end.
- Remove the inner tie rod from the steering rack using an adjustable wrench to gently support the steering rack shaft and an 42mm open end. (This joint has Loctite, you may need to add heat)
- Measure the factory tie rod assembly before installation. Measure from the face of the inner joint to the center of the outer rod end and record the measurement below.
- Break inner and outer joint apart and remove the boot with a 24 and 27 mm open ended wrench.
- Record: Driver side ____ / Passenger side ____
Installation
- Clean the steering rack threads.
- Apply red Loctite to the inner joint.
- Tighten the inner joint to the steering rack with a 41mm open end and an adjustable wrench to gently support the rack. Torque to 100 ft-lbs.
- Slip the dust boot and factory hose clamp over the inner joint.
- Assemble your Kryptonite body to the inner & outer joints. Match the length to the factory tie rods using the measurements taken earlier.
- Assemble the outer joint to the knuckle using an 8 mm Allen and a 24 mm ratchet open end. Torque the outer knuckle nut to 52 ft-lbs +90°. (Figure 1)
- Slide the dust boot over the rack and secure it with a zip tie. Use the factory clamp on the small side of the steering rack boot. (Figure 2)
- Reinstall the wheels, torque to 148 ft-lbs. Do not use anti-seize.
- Set vehicle on the ground, steer ahead straight, set 1/8” toe. Eyeball the front tire to ensure it’s parallel to the rear tire on both sides. Torque the jam nuts to 89 ft-lbs.
Warnings
- Do not use anti-seize.
- This joint has Loctite, you may need to add heat.
Important safety and legal information
Installation should be performed by a qualified technician. Improper installation may result in vehicle damage, loss of control, serious injury, or death. Always support the vehicle securely with jack stands. Never rely on a jack alone. Verify all components are installed correctly and torqued to specification before operating the vehicle. After installation, inspect suspension and steering components and check for proper clearance through full travel. Re-torque all hardware after initial use and periodically thereafter. User assumes all responsibility for compliance with local laws. Manufacturer is not responsible for damage or injury resulting from improper installation, misuse, or modification. By installing this product, the user accepts all risk and liability associated with its use.