2005-2023 FORD STEERING KIT INSTALLATION
Installation instructions for the Kryptonite Steering Kit (KRFSK05). Used with: Kryptonite Steering Kit for 2005-2026 Ford Super Duty F-250/F-350.
Quick reference
- Part numbers: KRFSK05
- Tie rod and drag link end nuts: 85 ft-lbs
- Jam nuts: 200 ft-lbs
Text version of these instructions
Removal
- Park on a level surface and chock rear tires. Raise the front of the truck and support with jack stands under the frame. Remove front wheels. Remove the stabilizer at this time (if present).
- Loosen the nuts on the tie rod and drag link ends. Leave the nut on the studs to secure the tie rod and the drag link while breaking the taper connection.
- Once you have removed the old steering components, record their lengths from stud center to stud center.
- Record: Drag Link: ____ / Tie Rod: ____
Assembly
- Apply anti seize to the threaded portions of the rod ends before assembly. Do not apply anti seize to the surface of the jam nuts. This surface must remain clean and dry.
- To assemble the drag link, place the notched ends (Figure 1) into the notched ends of the drag link & tie rod. Ensure the tapered end of the jam nut is facing the center of the body (Figure 2).
- Adjust the Kryptonite Steering Kit to match the recorded measurements taken during disassembly.
- Snug the jam nuts to prevent unwanted adjustment during installation.
Installation
- With the new parts adjusted to the recorded measurements, install the tie rod into the factory mounting locations. Leave the hardware loose at this time to allow for final adjustment and alignment.
- Install the drag link to the pitman arm and steering knuckle using the supplied hardware. Verify the drag link is oriented correctly before tightening.
- Torque the tie rod and drag link end nuts to 85 ft-lbs. Torque all jam nuts to 200 ft-lbs.
- Reinstall any removed components, including the stabilizer. Reinstall the front wheels.
- Lower the vehicle to the ground and verify the steering wheel is centered. A professional alignment is required after installation.
- Torque diagram legend (colour marks on the parts photo): open light-blue circle = 85 ft-lbs (on the end studs); filled red dot = 200 ft-lbs (on the jam nuts).
Warnings
- Do not apply anti seize to the surface of the jam nuts. This surface must remain clean and dry.
- A professional alignment is required after installation.
Important safety and legal information
Installation should be performed by a qualified technician. Improper installation may result in vehicle damage, loss of control, serious injury, or death. Always support the vehicle securely with jack stands. Never rely on a jack alone. Verify all components are installed correctly and torqued to specification before operating the vehicle. After installation, inspect suspension and steering components and check for proper clearance through full travel. Re-torque all hardware after initial use and periodically thereafter. User assumes all responsibility for compliance with local laws. Manufacturer is not responsible for damage or injury resulting from improper installation, misuse, or modification. By installing this product, the user accepts all risk and liability associated with its use.