2003-2013 RAM T-LINK STEERING KIT INSTALLATION
Installation instructions for the Kryptonite 2003-2013 Ram Steering Kit (KRDSK03). Used with: Kryptonite Steering Kit for 2003-2013 RAM 2500/3500.
Quick reference
- Part numbers: KRDSK03
- Jam nuts (retorque after alignment): 200ft/lbs
Text version of these instructions
Removal
- Loosen Steering Stabilizer (if equipped) and set aside.
- Loosen all nut fasteners on the tie rod ends, do the same on the drag link ends. You will leave the nut on the studs to secure the tie rod and the drag link while breaking the taper connection.
- Measure the length (stud to stud) (Figure 1) on the drag link and tie rod and record below.
- Record: Drag Link Length: ____ / Tie Rod Length: ____
Assembly
- Thread the rod ends onto the corresponding bodies (Figure 2), use Anti-Seize on the threads of the tie rod and drag link ends. DO NOT get any Anti-Seize on the surface of the jam nut to tie rod and drag link body.
- Adjust the length to match the factory measurements you recorded above.
- Hand tighten the Jam nuts, these will be torqued in step 3 of installation.
Installation
- Install the tie rod onto the knuckles and leave hand tight.
- Install the drag link at the pitman arm and the passenger side tie rod end.
- Torque all fasteners as shown in (Figure 3).
- Be sure to get a professional alignment immediately to avoid uneven tire wear.
- After alignment be sure to retorque all the jam nuts as they are loosened during the alignment process. Torque to 200ft/lbs.
- Figure 3 marks fasteners with a cyan circle (100 ft-lbs), a red dot (200 ft-lbs) and a yellow circle (71 ft-lbs). The design does not name the fasteners these values apply to.
Warnings
- DO NOT get any Anti-Seize on the surface of the jam nut to tie rod and drag link body.
Important safety and legal information
Installation should be performed by a qualified technician. Improper installation may result in vehicle damage, loss of control, serious injury, or death. Always support the vehicle securely with jack stands. Never rely on a jack alone. Verify all components are installed correctly and torqued to specification before operating the vehicle. After installation, inspect suspension and steering components and check for proper clearance through full travel. Re-torque all hardware after initial use and periodically thereafter. User assumes all responsibility for compliance with local laws. Manufacturer is not responsible for damage or injury resulting from improper installation, misuse, or modification. By installing this product, the user accepts all risk and liability associated with its use.